Installing An Sfp Or Xfp Transceiver Into An Mx960 Dpc, Mpc, Mic, Or Pic - Juniper MX960 Hardware Manual

Installing an SFP or XFP Transceiver into an MX960 DPC, MPC, MIC, or PIC

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Place a rubber safety cap over the transceiver.
8.
Place the removed transceiver on an antistatic mat or in an electrostatic bag.
9.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
To install an SFP or XFP:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Carefully align the transceiver with the slots in the component. The connectors should
4.
face the component.
Slide the transceiver until the connector is seated in the component slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
6.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
7.
the cable into the transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Verify that the status LEDs on the component faceplate indicate that the SFP or XFP
8.
is functioning correctly. For more information about the component LEDs, see the
Series Interface Module Reference
Preventing Electrostatic Discharge Damage to an MX960 Router
Replacing an MX960 PIC on page 382
Chapter 27: Replacing Switch Fabric Components
.
MX
439