MX960 3D Universal Edge Router Hardware Guide
Reinstalling the DPCs After Installing the MX960 Router with a Lift
220
Grasp both ejector handles, and rotate them simultaneously clockwise until the SCB
4.
is fully seated.
Place the ejector handles in their proper position, vertically and toward the center of
5.
the board. To avoid blocking the visibility of the LEDs position the ejectors over the
PARK icon.
Figure 66: Reinstalling an SCB
To reinstall a DPC (see
Figure 67 on page
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each DPC to be installed out of its electrostatic bag, and identify the slot on the
2.
DPC where it will be connected.
Verify that each fiber-optic DPC has a rubber safety cap covering the transceiver. If it
3.
does not, cover the transceiver with a safety cap.
221):
Copyright © 2017, Juniper Networks, Inc.