Replacing Connections To Mx960 Routing Engine Interface Ports - Juniper MX960 Hardware Manual

Related
Documentation

Replacing Connections to MX960 Routing Engine Interface Ports

Copyright © 2017, Juniper Networks, Inc.
After the Esc key is pressed,
screen.
Using Up or Down arrow keys, navigate to
4.
Using Up or Down arrow keys, navigate through the EFI boot devices listed and select
5.
to boot from the PXEboot server and press the Enter key.
EFI Network 0 for IPv4
Booting `net boot console
6.
NOTE: The booting process may take several minutes.
After the Routing Engine boots, press
7.
vmhost and Junos software on Primary and Secondary disk [y/N]?
After the installation is completed, press y when prompted to confirm
8.
to reboot from the SSD disk.
[y/N]?
Copying vmhost and Junos OS when only one disk is replaced:
a. Bring the Routing Engine online by pressing the
b. The router boots from disk1 if disk2 is replaced. To be able to boot from disk2:
user@host>
request vmhost snapshot partition
The router boots from disk2 if disk1 is replaced. To be able to boot from disk1:
user@host>
request vmhost snapshot recovery partition
Returning a Hardware Component to Juniper Networks, Inc. on page 527
Upgrading the SSD Firmware on RE-S-X6-64G and RE-MX2K-X8-64G Routing Engines
Replacing the Management Ethernet Cable on an MX Series Router on page 344
Replacing the Console or Auxiliary Cable on an MX960 Router on page 344
Chapter 24: Replacing Host Subsystem Components
Esc is pressed. Go to boot options.
Boot Manager
is displayed and PXEBoot continues.
y when you are prompted to confirm
ONLINE/OFFLINE
is displayed on the
and press the Enter key.
Install
on the console.
Reboot now?
button.
343