Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation
Connecting DC Power to an EX6200 Switch
180
Repeat Steps
9
and
10
11.
inlet on the 5000 W AC power supply.
If the AC power source outlet has a power switch, set it to the ON (|) position.
12.
Verify that the
INPUT OK
13.
Repeat Steps
2
through
14.
Figure 66: Connecting the Power Supply Cord to an EX6200 Switch Using
a 2500 W AC Power Supply
Tighten
adjustment
nut.
Figure 67: Connecting the Power Supply Cord to an EX6200 Switch Using
a 5000 W AC Power Supply
Tighten
adjustment
nut.
Powering On an EX6200 Switch on page 184
AC Power Supplies in an EX6200 Switch on page 38
AC Power Supply LEDs in an EX6200 Switch on page 47
An EX6200 switch can be configured with up to four DC power supplies. After you have
installed at least one power supply, you can connect power to the switch.
NOTE:
Grounding is required for DC systems and recommended for AC
systems.
if you are connecting a power cord to the second appliance
LED on the power supply faceplate is lit and is on steadily.
13
for the remaining power supplies.
Copyright © 2014, Juniper Networks, Inc.