Supported Network Interface Standards By Transceiver For Acx Series, Mx Series, M Series, And T Series Routers - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation
Supported Network Interface Standards by Transceiver for ACX Series, MX Series, M
Series, and T Series Routers
134
Understanding Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion on page 139
Calculating Power Budget and Power Margin for Fiber-Optic Cables on page 140
Table 67 on page 135 and Table 68 on page 138
MX, M, and T Series devices.
NOTE: Not all transceivers are supported on all devices. To determine which
transceivers are supported in a particular device, see the "Cables and
Connectors" section for each PIC, MIC, or line card in the Interface Module
Reference for your device, or see the
TIP: You can use the
the pluggable transceivers supported on your Juniper Networks device.
Table 67 on page 135 lists the supported Ethernet standards for each transceiver.
Table 68 on page 138 lists the supported SONET standards for each transceiver.
Some transceivers support monitoring by using the operational mode CLI command
show interfaces diagnostics optics
refer to the "Monitoring Available" column in
For a description of the monitoring fields displayed by the transceiver, see show interfaces
diagnostics optics (Gigabit Ethernet, 10-Gigabit Ethernet, 40-Gigabit Ethernet, 100-Gigabit
Ethernet, and Virtual Chassis Port) or show interfaces diagnostics optics (SONET).
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
NOTE: For XFP transceivers that can support either the 10-Gigabit Ethernet
or SONET OC192/STM64 specifications, check the standard supported for
the device into which the transceiver is installed. For example, the
XFP-10G-E-OC192-IR2 transceiver installed in a 10-Gigabit Ethernet PIC
supports the 10GBASE-E standard. However, the XFP-10G-E-OC192-IR2
transceiver installed in a SONET OC192/STM64 PIC supports the SONET
OC192/STM64 IR2 standard.
list the transceivers supported by ACX,
Hardware Compatibility Tool
Hardware Compatibility Tool
. To determine which transceivers support monitoring,
Table 67 on page 135
Copyright © 2017, Juniper Networks, Inc.
.
to find information about
and Table 68 on page 138.