Troubleshooting The Mx960 Mpcs - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide

Troubleshooting the MX960 MPCs

Problem
Solution
496
Description: The MPCs are not functioning normally.
Monitor the green LED labeled
MPC is seated in an operating router.
The Routing Engine downloads the MPC software to it under two conditions: The MPC
is present when the Routing Engine boots Junos OS, and the MPC is installed and
requested online through the CLI or push button on the front panel. The MPC then runs
diagnostics, during which the
normally, the LED lights green steadily.
OK
Make sure the MPC is properly seated in the midplane. Check that each ejector handle
has been turned clockwise and is tight.
Check the OK/FAIL LED on the MPC and
interface. When the MPC is online and functioning normally, the
steadily.
Issue the show chassis fpc
in the sample output, the value
MPC is functioning normally:
user@host> show chassis fpc
Temp
Slot State (C)
0 Online 36
1 Online 40
2 Online 41
3 Online 43
4 Online 24
5 Empty
6 Online 43
7 Empty
8 Empty
9 Empty
10 Online 24
11 Empty
NOTE: The show chassis fpc
For more detailed output, add the
a slot number, which is optional:
user@host> show chassis fpc detail
Slot 0 information:
State
Temperature
Total CPU DRAM
Total RLDRAM
OK above the MPC on the craft interface as soon as an
OK LED blinks. When the MPC is online and functioning
OK and FAIL
command to check the status of installed MPCs. As shown
in the column labeled
Online
CPU Utilization (%) Memory
Total Interrupt DRAM (MB) Heap
3 0 2048
5 0 2048
6 0 1024
5 0 1024
3 0 1024
5 0 1024
3 0 1024
command displays the status of the MPCs.
detail option. The following example does not specify
Online
33 degrees C / 91 degrees F
1024 MB
256 MB
line card LEDs on the craft
LED lights green
OK
indicates that the
State
Utilization (%)
Buffer
14 13
26 13
7 43
16 57
13 21
16 57
13 21
Copyright © 2017, Juniper Networks, Inc.