Copyright © 2017, Juniper Networks, Inc.
Figure 185: MX960 with High-Capacity AC Power Supplies Installed
Air exhaust
AC Power
supplies
Power supply
ejectors
Protective earthing
If necessary, pull the spring-loaded locking pin in the release lever away from the
chassis and turn the release lever counterclockwise until it stops. Let go of the locking
pin in the release lever. Ensure that the pin is seated inside the corresponding hole in
the chassis.
On the power supply, rotate the metal cover away from the input mode switch to
3.
expose the switch.
Move the input mode switch to position 0 for one feed or position 1 for two feeds (see
4.
Figure 72 on page
230).
Chapter 30: Converting to a Different Type of Power Supply
Input mode switch
ESD point
481