Holding An Mx960 Dpc - Juniper MX960 Hardware Manual

MX960 3D Universal Edge Router Hardware Guide
Related
Documentation

Holding an MX960 DPC

452
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 7 Offline
For further description of the output from the command, see the
MX960 Chassis Description on page 9
MX960 Dense Port Concentrator Description on page 53
MX960 DPC and MPC LEDs on the Craft Interface on page 18
Troubleshooting the MX960 DPCs on page 490
Replacing an MX960 DPC on page 355
When carrying a DPC, you can hold it either vertically or horizontally.
NOTE: A DPC weighs 14.5 lb (6.6 kg). Be prepared to accept the full weight
of the DPC as you lift it.
To hold a DPC vertically:
Orient the DPC so that the faceplate faces you. To verify orientation, confirm that the
1.
text on the DPC is right-side up and the electromagnetic interference (EMI) strip is on
the right-hand side.
Place one hand around the DPC faceplate about a quarter of the way down from the
2.
top edge. To avoid deforming the EMI shielding strip, do not press hard on it.
Place your other hand at the bottom edge of the DPC.
3.
If the DPC is horizontal before you grasp it, place your left hand around the faceplate and
your right hand along the bottom edge.
To hold a DPC horizontally:
Orient the DPC so that the faceplate faces you.
1.
Grasp the top edge with your left hand and the bottom edge with your right hand.
2.
You can rest the faceplate of the DPC against your body as you carry it.
As you carry the DPC, do not bump it against anything. DPC components are fragile.
1x 10GE(LAN/WAN)
1x 10GE(LAN/WAN)
1x 10GE(LAN/WAN)
1x 10GE(LAN/WAN)
MX960 4 XGE DPC
.
CLI Explorer
Copyright © 2017, Juniper Networks, Inc.