Figure 168: Connecting Power Cables To The Dc Power Supply - Juniper MX960 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.

Figure 168: Connecting Power Cables to the DC Power Supply

Terminal
studs
Cable
lug
Split
washer
Nut
Route the power cable through the cable restraint. Make sure that the cable does not
5.
touch or obstruct any router components.
Tighten the cable restraint captive screw to hold the power cables in place.
6.
Verify that the DC power cable is connected correctly, that it does not touch or block
7.
access to router components, and that it does not drape where people could trip on
it.
Replace the clear plastic cover over the terminal studs on the faceplate.
8.
Attach the power cable to the DC power source.
9.
Turn on the dedicated customer site circuit breaker to the power supply.
10.
Verify that the
INPUT OK
11.
On each of the DC power supplies, switch the DC circuit breaker to the center position
12.
before moving it to the on (
NOTE: The circuit breaker may bounce back to the off (
move the breaker too quickly.
Chapter 26: Replacing Power System Components
LED on the power supply is lit steadily.
) position.
|
) position if you
O
407