Scbe2-Mx Leds; Table 62: Scbe2-Mx Leds - Juniper MX960 Hardware Manual

SCBE2-MX LEDs

Copyright © 2017, Juniper Networks, Inc.
,
FABRIC ACTIVE FABRIC ONLY
The , , and LEDs, located next to the
BITS GPS UTI
respective clocking interface. The
indicate the status of the respective SFP+ interface.
functions of the SCBE2-MX LEDs.

Table 62: SCBE2-MX LEDs

Label Color
Green
FABRIC
ACTIVE
FABRIC Green
ONLY
–
Green
OK/FAIL
Red
–
Green
BITS
Red
–
Green
GPS
Red
–
Green
UTI
Red
–
Green
LINK
–
Chapter 8: Switch Fabric Components and Descriptions
, and LEDs indicate the status of the SCBE2-MX.
OK/FAIL
EXT CLK
LINK LED located next to the two Ethernet ports,
Table 62 on page 117
State Description
On steadily Fabric is in active mode.
On steadily SCBE2-MX operates in fabric-only mode.
Off SCBE2-MX operates in fabric or control-board mode.
On steadily SCBE2-MX is online.
On steadily SCBE2-MX has failed.
Off SCBE2-MX is offline.
On steadily Building-integrated timing supply (BITS) clocking
interface is active.
On steadily BITS clocking interface has failed.
Off BITS clocking interface is offline.
On steadily Global positioning system (GPS) clocking interface
is active.
On steadily GPS clocking interface has failed.
Off GPS clocking interface is offline.
On steadily Universal Timing Interface (UTI) clocking interface
is active.
On steadily UTI clocking interface has failed.
Off UTI clocking interface is offline.
On steadily Port is enabled and link is established.
Off Port is disabled or no link is established.
port, indicate the status of the
describes the
117