Juniper MX960 Hardware Manual page 556

MX960 3D Universal Edge Router Hardware Guide
526
Remove the shipping brackets and hardware, and set them aside.
Guide the router in the shipping crate.
Using a router transport kit:
Position the router transport platform in front of the rack, and adjust the four leveling
mounts using an 8 mm Allen wrench to align the platform with the bottom of the
mounting shelf and the chassis.
Unscrew and remove the mounting screws from the front mounting flange on the
rack.
A minimum of four people can then slide the router onto the router transport platform
by using the handles on the shipping covers.
Secure the four toggle latches to the router transport platform.
Using a two person team, adjust the height on the router transport platform to install
the router transport mounting plates and wheel assembly.
WARNING: Do not raise the router more than 1 in. (2.54 cm). Doing so
can make the router unstable.
Attach the router transport mounting plates and wheel assembly to both sides of
the chassis using the captive screws, tighten to secure.
NOTE: You may have to adjust the wheel assembly to installed the
router transport mounting plates.
Using a two person team, crank the handles 4-5 times until the router is lifted
approximately 1 in. (2.54 cm).
WARNING: Do not raise the router transport over the required limit.
Doing so can make the router unstable during transport.
Unlatch the four toggle latches that secure the router transport platform to the
router mounting plate and wheel assembly.
Remove the router transport platform away from the bottom of the router, and set
aside
Position the crate door in front of the shipping crate and secure the two latches.
Guide the router up the ramp and into the shipping crate.
Lower the router until the chassis is resting firmly onto the shipping crate platform.
Remove the router transport mounting plates and wheel assembly from the chassis.
Copyright © 2017, Juniper Networks, Inc.