Installing An Mx10003 Ac Power Supply - Juniper MX10003 Hardware Manual

Installing an MX10003 AC Power Supply

To install an AC power supply (see
1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
2. Using both hands, hold and slide the AC power supply straight into the chassis until the power supply
is fully seated in the chassis slot. The power supply faceplate must alligned with any adjacent power
supply faceplate or blank installed in the power supply slot.
3. Press the latch located on the left side of the power supply to slide it into the chassis.
4. Attach the power cord to the power supply.
5. Attach the power cord to the AC power source, and switch on the dedicated customer-site circuit
breaker. Follow the instructions for your site.
6. Observe the status LED on the power supply faceplate. If the power supply is correctly installed and
functioning normally, the status LED lights green steadily.
Figure 41: Installing an AC Power Supply
SEE ALSO
MX10003 AC Power System Description | 35
MX10003 Router AC Power Specifications | 37
AC Power Circuit Breaker Requirements for the MX10003 Router | 38
AC Power Cord Specifications for MX10003 Routers | 39
Figure 41 on page 129):
129