Replacing Connections To Mx480 Routing Engine Interface Ports - Juniper MX480 Hardware Manual

Replacing Connections to MX480 Routing Engine Interface Ports

IN THIS SECTION
Replacing the Management Ethernet Cable on an MX Series Router | 312
Replacing the Console or Auxiliary Cable on an MX480 Router | 313
Replacing the Management Ethernet Cable on an MX Series Router
One Ethernet cable with RJ-45 connectors is provided with the router. To replace the cable connected to
the ETHERNET port:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Press the tab on the connector, and pull the connector straight out of the port.
shows the connector.
3. Disconnect the cable from the network device.
4. Plug one end of the replacement cable into the ETHERNET port.
5. Plug the other end of the cable into the network device.
Figure 103: Cable Connector
Figure 104: Ethernet Port
Figure 90 on page 287
Figure 91 on page 287 shows the port.
312