Replacing Connections To Mx240 Routing Engine Interface Ports; Replacing The Management Ethernet Cable On An Mx240 Router - Juniper mx240 Hardware Manual

Related
Documentation

Replacing Connections to MX240 Routing Engine Interface Ports

Replacing the Management Ethernet Cable on an MX240 Router

Copyright © 2016, Juniper Networks, Inc.
Remove the storage drive.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
a.
connect the strap to an ESD point on the appliance.
For more information about ESD, see Preventing Electrostatic Discharge Damage
in the hardware guide for your router.
Unfasten the thumbscrew that secures the access door in front of the storage drive
b.
slots, and open the door.
Slide the lock on the ejector to the unlocked position.
c.
Carefully slide the drive out of the slot.
d.
Reinstall a storage drive.
3.
Carefully align the sides of the drive with the guides in the slot.
a.
Slide the drive into the slot until you feel resistance, carefully ensuring that it is
b.
correctly aligned.
Close the access door and tighten the thumbscrew to secure the door.
c.
Returning a Hardware Component to Juniper Networks, Inc. on page 405
Replacing the Management Ethernet Cable on an MX240 Router on page 269
Replacing the Console or Auxiliary Cable on an MX240 Router on page 270
One Ethernet cable with RJ-45 connectors is provided with the router. To replace the
cable connected to the ETHERNET
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the port.
2.
Figure 118 on page 270
Disconnect the cable from the network device.
3.
Plug one end of the replacement cable into the
4.
shows the port.
Plug the other end of the cable into the network device.
5.
Chapter 24: Replacing Host Subsystem Components
port:
shows the connector.
ETHERNET
port. Figure 119 on page 270
269