Replacing Connections To Mx240 Routing Engine Interface Ports; Replacing The Management Ethernet Cable On An Mx240 Router - Juniper MX240 Hardware Manual

Replacing Connections to MX240 Routing Engine Interface Ports

IN THIS SECTION

Replacing the Management Ethernet Cable on an MX240 Router | 299

Replacing the Console or Auxiliary Cable on an MX240 Router | 300
Replacing the Management Ethernet Cable on an MX240 Router
One Ethernet cable with RJ-45 connectors is provided with the router. To replace the cable connected to
the ETHERNET port:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Press the tab on the connector, and pull the connector straight out of the port.
shows the connector.
3. Disconnect the cable from the network device.
4. Plug one end of the replacement cable into the ETHERNET port.
5. Plug the other end of the cable into the network device.
Figure 91: Cable Connector
Figure 92: Ethernet Port
Figure 91 on page 299
Figure 92 on page 299 shows the port.
299