Supported Network Interface Standards By Transceiver For Acx Series, M Series, Mx Series, And T Series Routers; Series, And T Series Routers - Juniper mx240 Hardware Manual

MX240 3D Universal Edge Router Hardware Guide
Related
Documentation
Supported Network Interface Standards by Transceiver for ACX Series, M Series, MX

Series, and T Series Routers

114
SONET/SDH OC48/STM16 Optical Interface Specifications
SONET/SDH OC192/STM64 Optical Interface Specifications
Understanding Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion on page 122
Calculating Power Budget and Power Margin for Fiber-Optic Cables on page 123
Table 60 on page 115 and Table 61 on page 121
MX, and T Series devices.
NOTE: Not all transceivers are supported on all devices. To determine which
transceivers are supported in a particular device, see the "Cables and
Connectors" section for each PIC, MIC, or line card in the Interface Module
Reference for your device.
Table 60 on page 115 lists the supported Ethernet standards for each transceiver.
Table 61 on page 121 lists the supported SONET standards for each transceiver.
Some transceivers support monitoring by using the operational mode CLI command
show interfaces diagnostics optics
refer to the "Monitoring Available" column in
For a description of the monitoring fields displayed by the transceiver, see show interfaces
diagnostics optics (Gigabit Ethernet, 10-Gigabit Ethernet, 40-Gigabit Ethernet, 100-Gigabit
Ethernet, and Virtual Chassis Port) or show interfaces diagnostics optics (SONET).
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
NOTE: For XFP transceivers that can support either the 10-Gigabit Ethernet
or SONET OC192/STM64 specifications, check the standard supported for
the device into which the transceiver is installed. For example, the
XFP-10G-E-OC192-IR2 transceiver installed in a 10-Gigabit Ethernet PIC
supports the 10GBASE-E standard. However, the XFP-10G-E-OC192-IR2
transceiver installed in a SONET OC192/STM64 PIC supports the SONET
OC192/STM64 IR2 standard.
list the transceivers supported by ACX, M,
. To determine which transceivers support monitoring,
Table 60 on page 115
Copyright © 2016, Juniper Networks, Inc.
and Table 61 on page 121.