Supported Network Interface Standards By Transceiver For Acx Series, M Series, Mx Series, And T Series Routers - Juniper acx1000 User Manual

ACX1000 and ACX1100 Universal Access Router
Supported Network Interface Standards by Transceiver for ACX Series, M Series, MX
Series, and T Series Routers
68
Table 27 on page 69 and Table 28 on page 75
MX, and T Series devices.
NOTE: Not all transceivers are supported on all devices. To determine which
transceivers are supported in a particular device, see the "Cables and
Connectors" section for each PIC, MIC, or line card in the Interface Module
Reference for your device, or see the
TIP: You can use the
the pluggable transceivers supported on your Juniper Networks device.
Table 27 on page 69 lists the supported Ethernet standards for each transceiver.
Table 28 on page 75 lists the supported SONET standards for each transceiver.
Some transceivers support monitoring by using the operational mode CLI command
show interfaces diagnostics optics
refer to the "Monitoring Available" column in
For a description of the monitoring fields displayed by the transceiver, see show interfaces
diagnostics optics (Gigabit Ethernet, 10-Gigabit Ethernet, 40-Gigabit Ethernet, 100-Gigabit
Ethernet, and Virtual Chassis Port) or show interfaces diagnostics optics (SONET).
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
NOTE: For XFP transceivers that can support either the 10-Gigabit Ethernet
or SONET OC192/STM64 specifications, check the standard supported for
the device into which the transceiver is installed. For example, the
XFP-10G-E-OC192-IR2 transceiver installed in a 10-Gigabit Ethernet PIC
supports the 10GBASE-E standard. However, the XFP-10G-E-OC192-IR2
transceiver installed in a SONET OC192/STM64 PIC supports the SONET
OC192/STM64 IR2 standard.
Table 27 on page 69 is organized by transmission speed and then alphabetically by model
number.
list the transceivers supported by ACX, M,
Hardware Compatibility Tool
Hardware Compatibility Tool
. To determine which transceivers support monitoring,
Table 27 on page 69
Copyright © 2017, Juniper Networks, Inc.
.
to find information about
and Table 28 on page 75.