Pbx Configuration-[3-1-3] Group-Trunk Group-Caller Id Modification - Panasonic KX-NS1000 Pc Programming Manual

11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller
ID Modification
The telephone numbers of incoming callers can be modified automatically according to pre-programmed
modification tables, and then recorded for calling back.
Leading Digits
After the caller's number is modified by the Length of Digits Modification Tables or CLIP Modification Tables,
the PBX checks the leading digits of the modified number for an area code programmed in the Caller ID
Modification Table assigned to that trunk group. If it finds such a code, it removes digits and adds a number
to the modified number. If this number is stored as a System Speed Dialing number, the caller's name can be
shown on a PT display and the call can be routed to a certain extension (CLI destination). A maximum of 4
Caller ID Modification Tables, each containing 10 local/international call data and 1 long distance code, can
be programmed. Each trunk group can select a table for use. Select the desired table from the Modification
Table list.
If the modified number does not contain an area code programmed here, the PBX applies the Long Distance
Code settings to the modified number.
Area Code (for Local / International Call Data 1–10)
Specifies the leading number (area code) to look for in the incoming caller's number.
Default
Local / International Call Data1–9: Not stored.
Local / International Call Data 10: 011
Value Range
Max. 6 digits (consisting of 0–9, *, and #)
Maintenance Console Location
11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification
Feature Manual References
4.1.3 Caller ID
Removed Number of Digits
Specifies the number of digits to be removed from the beginning of the incoming caller's number.
Default
Local / International Call Data1–9: 3
Local / International Call Data 10: 0
Long Distance Code: 0
Value Range
0–9
Document Version 2016-03
11.1.3 PBX Configuration—[3-1-3] Group—Trunk Group—Caller ID Modification
PC Programming Manual 631