Router Configuration-Setup-[1-1-2] Router Information-Pppoe Status - Panasonic KX-NS1000 Pc Programming Manual

27.1.2 Router Configuration—Setup—[1-1-2] Router
Information—PPPoE Status
PPPoE Session Name
Indicates the PPPoE session name (reference only).
Default
Not stored
Value Range
Max. 20 characters
Maintenance Console Location
27.1.2 Router Configuration—Setup—[1-1-2] Router Information—PPPoE Status
Status
Indicates the PPPoE connection status (reference only).
To change the status, click the button next to the Status display (It will display Connect or Disconnect
depending on the current status).
Note
•
If IP Address Configuration Mode shows "-", the button will be grayed out.
•
If Connection Mode (refer to 27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection
Settings—
Configuration—Setup—[1-2-1] WAN—Connection Settings—PPPoE—
Disable, the button will be grayed out.
•
The button is available only for Installer level and User (Administrator) level accounts.
Default
No Connect
Value Range
No Connect: The session is not connected.
Connecting: The session is in the process of being connected (not yet connected with the server).
Connected: The session is connected.
Fault: A fault has occurred (before or during connection).
Disconnected: The session was disconnected by the user.
Maintenance Console Location
27.1.2 Router Configuration—Setup—[1-1-2] Router Information—PPPoE Status
IP Address Configuration Mode
Indicates the IP address configuration mode (reference only).
Default
Dynamic IP
Document Version 2016-03
27.1.2 Router Configuration—Setup—[1-1-2] Router Information—PPPoE Status
Connection Mode) is PPPoE, and Session Enabled (refer to 27.2.1 Router
Session Enabled) is set to
PC Programming Manual 1093