7.8 Utility—Command
7.8.1 Utility—Command—UM Command
System commands can be sent directly to the Unified Messaging system using the Commands dialog.
This screen can be accessed only in On-line mode.
Follow the steps below to use the Commands dialog:
1.
Enter the desired command, then click RUN. Results from entered commands are displayed.
2.
When finished, click Close.
7.8.2 Utility—Command—Router Command
Router commands can be sent directly to the built-in router using the Commands dialog.
This screen can be accessed only in On-line mode.
Follow the steps below to use the Commands dialog:
1.
Enter the desired command, then click RUN. Results from entered commands are displayed.
2.
When finished, click Close.
Note
•
Some examples of supported commands are as follows: ROUTE, NETSTAT, ARP, DNSFLUSH.
Document Version 2016-03
7.8.2 Utility—Command—Router Command
PC Programming Manual
157