Panasonic KX-NS1000 Pc Programming Manual page 887

VM Trunk Group No.
Specifies the number of the VM trunk group sent to the VPS when the incoming call destination is the floating
extension number of a VM (DPT) Group (connected to a KX-NCP/KX-TDE series PBX). The VM trunk group
number is used to allow the VPS to send the applicable greeting message to the caller.
Default
1
Value Range
1–48
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
CLI for DIL
When CLI distribution is enabled for a CO line to which DIL distribution is set, incoming CO line calls will be
distributed to the CLI destinations (instead of the DIL destinations) if the caller's identification number is found
in the System Speed Dialing Table.
CLI distribution can be enabled or disabled for each time mode (day/lunch/break/night) on a CO line basis.
The Site, Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
Card Type
Indicates the CO line card type (reference only).
Default
Current card type
Value Range
Card type
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Manual References
10.1.11 INCOMING CALL FEATURES
Trunk Property
Indicates the networking type of each CO line (reference only).
Default
Current networking type
Value Range
Public, Private(TIE), VPN
Document Version 2016-03
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
PC Programming Manual 887