Panasonic KX-NS1000 Pc Programming Manual page 416

9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
Value Range
1–2 ms
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
Jitter Buffer - Initial Delay
Specifies the initial size of the jitter buffer for voice communications.
Default
2
Value Range
1–7 ms
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
Gain Type
Specifies the type of gain file to distribute to connected SIP devices.
Default
Default
Value Range
Default, Type1, Type2, Type3
Maintenance Console Location
9.21 PBX Configuration—[1-1] Configuration—Slot—V-UTEXT32—Port Property
Secondary Setting
The settings on this screen are for programming the Automatic Rerouting to Secondary PBX feature for use
among IP extensions in a networked environment. For details and conditions regarding the use of this feature,
refer to 2.1.7 Automatic Rerouting to Secondary PBX in the Feature Manual.
Setting Secondary Ports
Follow the steps below to designate secondary ports for IP extensions.
1.
Specify the secondary ports.
a.
Access the port property screen of the site where the ports will be set as secondary ports.
b.
In Primary/Secondary, set the unused ports that will be used as secondary ports to "Secondary".
Note
Ports that have already been registered (A value other than the default of "00:00:00:00:00:00" is
set for
"Secondary" here.
416 PC Programming Manual
IP Phone Registration ID (MAC Address) on the Main tab) cannot be set to
Document Version 2016-03