Panasonic KX-NS1000 Pc Programming Manual page 886

18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Tenant Number
Specifies the tenant number, to determine the Time Table by which calls are distributed depending on the time
of day.
Default
1
Value Range
1–32
or
1–128
Note
The maximum number of tenants depends on the System Capacity Selection setting made when the
Easy Setup Wizard was run for the PBX. If the System Resource Type was selected, the maximum
number of tenants is 128. If the SIP Extension Type or IP-Extension Type was selected, the maximum
number of tenants is 32. For details, refer to 5.4.1 Easy Setup Wizard in the Installation Manual.
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Manual References
5.1.8 DIL (Direct In Line)
19.1.2 Tenant Service
19.1.3 Time Service
UM Service Group No.
Specifies the Service Group number sent to the Unified Messaging system when the incoming call destination
is the floating extension number of a UM group.
The Service Group number is used to allow the Unified Messaging system to send the applicable greeting
message to the caller.
Default
Not Stored
Value Range
None, 1–64
Maintenance Console Location
18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings
Feature Manual References
5.1.8 DIL (Direct In Line)
20.1.78 Unified Messaging—Service Group
886 PC Programming Manual Document Version 2016-03