Panasonic KX-NS1000 Pc Programming Manual page 947

Note
When the Unified Messaging system calls a CO line via the PRI card, be sure to add "#" after the telephone
number (1112223333 in the example here): 9P1112223333#PP123PP456PPX# (P: Dial Pause)
"X" is either the Caller ID information that was received when the message was recorded or the value of
System Callback No. if no Caller ID information was received.
Default
Not stored
Value Range
Max. 32 digits consisting of 0–9,
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
T: Dial Tone Detection
X: Callback Number Entry Code
0–9, , #: Dial Code
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Manual References
20.1.60 Unified Messaging—Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—No. of Retries
Specifies the number of times the Unified Messaging system will try to send notification if the device is busy
or if there is no answer.
Default
0
Value Range
0–9 times
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters
Feature Manual References
20.1.60 Unified Messaging—Message Waiting Notification—Telephone Device
Telephone Device—Device No. 1, 2, 3—Busy Delay Time (min)
Specifies the time (in minutes) the Unified Messaging system waits before retrying message notification when
the called device is busy.
Default
3
Document Version 2016-03
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
, # and special codes:
PC Programming Manual 947