Panasonic KX-NS1000 Pc Programming Manual page 1109

Maintenance Console Location
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
Disconnect when Idle timeout
If Enable is selected, configure the Disconnect when Idle timeout—Max Idle Time (x60s) setting.
If Disable is selected, Keep-Alive timer is not available.
Default
Disable
Value Range
Enable, Disable
Maintenance Console Location
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
Disconnect when Idle timeout—Max Idle Time (x60s)
Specifies a maximum idle time for which the internet connection is maintained during inactivity.
If Disable is selected for Connection on Demand or Disconnect when Idle timeout, this setting is grayed
out.
Default
5
Value Range
1–1440 min
Maintenance Console Location
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
LCP ECHO
If LCP ECHO is selected for PPP Keep-Alive, configure the parameters below.
Maintenance Console Location
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
LCP ECHO—LCP Echo Interval (s)
Specifies the LCP Echo Interval in seconds.
This value sets the interval between LCP echo requests sent by the PBX to the ISP.
If LCP ECHO is not selected for 27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection
Settings—PPPoE —
Default
10
Document Version 2016-03
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings
PPP Keep-Alive, this item is grayed out.
PC Programming Manual 1109