Panasonic KX-NS1000 Pc Programming Manual page 942

20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
Note
When "System" is selected, the Unified Messaging system uses the extension transfer sequence
pre-programmed in 24.4 UM Configuration—[5-4] System Parameters—Parameters—PBX
Parameters—
X , ;]).
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Mailbox Parameters
PC Programming Manual References
24.4 UM Configuration—[5-4] System Parameters—Parameters—PBX Parameters—
Environment—Extension Transfer Sequence (Up to 16 digits / [0-9 * # D R F T X , ;])
Feature Manual References
20.1.15 Unified Messaging—Call Transfer Status
Call Transfer Sequence (Other)
Specifies the Call Transfer Sequence used by the mailbox. Only specified if
(Selection) is set to "Other".
Default
Not stored
Value Range
Enter a maximum of 16 characters consisting of 0–9,
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialing
0–9, , #: Dial Code
Maintenance Console Location
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Mailbox Parameters
Feature Manual References
20.1.15 Unified Messaging—Call Transfer Status
No Answer Time (Selection/Other)
Specifies the length of time that the Unified Messaging system waits before handling unanswered calls to the
extension.
942 PC Programming Manual
PBX Environment—Extension Transfer Sequence (Up to 16 digits / [0-9 * # D R F T
Call Transfer Sequence
, # and special codes:
PBX
Document Version 2016-03