Panasonic KX-NS1000 Pc Programming Manual page 1021

Feature Manual References
20.1.27 Unified Messaging—Custom Service
Menu Repeat Cycle (1-3)
Specifies the number of times the Custom Service menu message will be repeated for the caller.
Default
3
Value Range
1–3 times
Maintenance Console Location
23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer
Feature Manual References
20.1.27 Unified Messaging—Custom Service
Call Transfer Anytime
Specifies the type of dialing that the system accepts during the Custom Service in addition to the single-digit
Custom Service options. This setting allows callers to dial numbers to connect themselves to an extension or
mailbox or enter a PIN.
Note
If you only need to allow callers to dial single-digit Custom Service option numbers, set this parameter to
"No". When set to a value other than "No", the system always waits for the amount determined by the Wait
for Second Digit (1-5 s) setting before handling the call. This will cause a delay between the time the
caller dials a single-digit Custom Service option number and when the call is actually handled.
Default
Extn
Value Range
Extn: Enables callers to be transferred directly to their intended party by dialing the extension number.
Mbx: Enables callers to leave messages in a mailbox by entering the mailbox number.
PIN: Enables callers to be transferred directly to the specified party according to the setting for PIN Call Routing
Service by dialing a PIN.
No: Disables extension transfer and mailbox transfer; only 1-digit entries will function (following the Custom
Service menu)
Maintenance Console Location
23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer
Feature Manual References
20.1.27 Unified Messaging—Custom Service
Document Version 2016-03
23.3.1 UM Configuration—[4-3] Service Settings—Custom Service—Menu & Transfer
PC Programming Manual 1021