Bgp Pw Configuration Example - HP HPE FlexNetwork MSR Router Series Configuration Manual

[PE3-vsi-aaa-ldp-2.2.2.9-500] quit
[PE3-vsi-aaa-ldp] quit
[PE3-vsi-aaa] quit
# Bind VSI aaa to GigabitEthernet 2/0/1 (the interface connected to CE 3).
[PE3] interface gigabitethernet 2/0/1
[PE3-GigabitEthernet2/0/1] xconnect vsi aaa
Verifying the configuration
# Verify that two LDP PWs in up state have been established on PE 1.
[PE1] display l2vpn pw verbose
VSI Name: aaa
Peer: 2.2.2.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs
Peer: 3.3.3.9
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs

BGP PW configuration example

Network requirements
Configure VPLS on each PE, and establish BGP PWs between the PEs to interconnect CEs.
PW ID: 500
: LDP
: 8 PW State : Up
: 1279 Out Label: 1279
: 1500
: Main
: -
: -
: 0x260000000
: 1028
PW ID: 500
: LDP
: 9 PW State : Up
: 1278 Out Label: 1277
: 1500
: Main
: -
: -
: 0x360000001
: 1029
476