Vision VR48 4 Series User Manual page 94

94 Vision VR48 Series 4 Router User Manual
CAUTION: Keep hands and fingers away from the spindle and cutter when performing this
procedure! Serious injury may result. Do not place your hands or fingers below the cutter when
setting the surface of your material!
To set the surface of your material:
1. Connect the sensor cable.
2. Install the Spindle Clamp on the bottom of the spindle.
3. Use the X and Y buttons on the Pendant to move the spindle over your material.
4. Place the Sensor Block on top of your material and hold as shown above.
5. Press the Set Surface button on the Pendant.
6. Press and Hold the Set Surface Button until the cutter tip touches the top of the Sensor Block. The
spindle will move down and stop when the cutter tip just touches the top of the Sensor Block. The
Controller will automatically calibrate and set the surface position of your material, then move the
spindle up approximately 1/4 inch and stop.
7. Release the Set Surface button.
8. Press the Go to Home button on the Pendant.
NOTE: The design of the Sensor Block is such that if the sensor does not detect the cutter tip
contacting the Sensor Block, the block will begin to tilt downward. If this occurs, release the Set
Surface button immediately and check for proper installation of the Sensor Cable and Spindle
Clamp.
© 2015 Vision Engraving and Routing Systems