Vision VR48 4 Series User Manual page 321

Creating Multiples and Serialization in Vision 9 Expert and Pro 321
We will now set the spacing and number of items per job. Set the number of copies to 30, set the
Margins to 0.00 and set the spacing to match our array - enter a vertical spacing of 4.00 and a
horizontal spacing of 5.00. Now, reduce the Plate size in the Plate portion of this window to only allow 5
columns and two rows. In this example, the size was reduced to 12 inches height and 38 inches width.
This size MUST be smaller than the engraving table size. This is critical in order for each job to only
produce 10 copies, which matches our template/fixture. The Multiples window should appear as shown
below. Note that in the Page preview, the parts are located starting in the upper left corner of the page
and there are 2 rows, 5 columns.
© 2015 Vision Engraving and Routing Systems