Vision VR48 4 Series User Manual page 330

330 Vision VR48 Series 4 Router User Manual
Change the Depth (and if desired, the number of passes and depth per pass) to what is needed for your
application, then select Change. In this example, a depth of 0.010 was entered and 1 pass will be used.
This will then set a temporary Depth and Number of Passes to all graphics of that particular color. Verify
that the changes have been made by hovering over the color swatch again with the mouse pointer.
All jobs sent to the engraver will now utilize the temporary depth and number of passes for the black
color. No tool paths need to be created. If the job is saved and re-opened later, the depth and number of
passes are retained with the file.
Setting depth for specific colors will not affect jobs sent to the machine with the proximity sensor turned
on and the default depth settings are not changed. The next new file created will use the standard depth
setting of 0.000 for all colors.
© 2015 Vision Engraving and Routing Systems