Vision VR48 4 Series User Manual page 241

Example Jobs 241
Move the spindle over your material and loosen the clamp holding the inserter. Lower the inserter to its
bottom position. this may require you to rotate the inserter so that the alignment holes are lined up.
There is a pin that will extend above the inserter flange when the inserter is at it's bottom position (shown
below). Tighten the clamp to secure the inserter.
Lower the spindle until the tip of the inserter contacts your material and the depth pin is flush with the top
of the inserter flange. Then press the Set Surface button on the Pendant and press Enter to set this
surface position. This procedure sets the proper pressure applied to the raster beads to insert them into
the holes we will drill. The top of the inserter flange is shown below with the pin flush with its top surface.
© 2015 Vision Engraving and Routing Systems