Vision VR48 4 Series User Manual page 294

294 Vision VR48 Series 4 Router User Manual
When finished modifying the image, select Arrange > Make Path to prepare the image for fills or tool
paths. To verify that the image will be filled in the areas you want, select the image, then click on the
center node of the image and hold down the mouse button. The areas that fills can be applied to will
appear as shaded areas, as shown below.
The image is now ready to be used.
A note about accuracy - It may have become noticeable that the vectorization process does not often
create smooth lines and curves - see image below. This is quite normal and consider that the image was
greatly increased in size before the vector image was created. If the image is reduced in size to a
typical size for engraving, these not so smooth lines will not be noticed. If it is important to make these
lines smooth, the image can be modified using the Node Edit tool.
© 2015 Vision Engraving and Routing Systems