Vision VR48 4 Series User Manual page 134

134 Vision VR48 Series 4 Router User Manual
After clicking on the Engrave icon on the left toolbar, make sure the DACS driver is selected as your
device. (DACS driver for small routers is shown in the below picture).
Send the job to the machine. When running Machine Tools, which is necessary when using the DACS
Camera System, the Pendant will show a preview of the job you have sent to the machine. Press Start
on the Pendant. The job will be recognized as using the DACS Camera and you will be prompted to
press Start to have the machine find the Fiducial Markers. Once the Fiducial Markers have been located
by the DACS software, the machine will pause and any adjustments needed to properly position the tool
path will be made automatically. You will be promoted to press Start to begin running the job at this time.
If the Fiducials are not found when running the job, you will be prompted to jog the motion system to the
first Fiducial Marker. Jog the motion system so that the top left Fiducial is displayed on the DACS
software screen. Follow the Pendant's on screen commands to have the camera system find the
Fiducial Markers and properly locate the cut tool path. Then, run the job.
If you have any issues when running the DACS Camera System, please contact Vision Technical
Support - 602-439-0700.
© 2015 Vision Engraving and Routing Systems