24
Vision VR48 Series 4 Router User Manual
2.6
Vacuum Pump Installation - Vacuum Table Models Only
The Main Vacuum Port for the VR48 is located at the foot of the machine. To connect the vacuum pump
to the machine, use the supplied 3" diameter vacuum hose and connect one end to the vacuum pump
and the other end to the Main Vacuum Port on the machine.
The vacuum pump has been equipped with an electrical connector designed for a 40 amp, 220 VAC, 3
phase power supply. A qualified and licensed electrician must be used to complete all wiring and
grounding of the vacuum pump according to all state, local, and national electrical codes.
© 2015 Vision Engraving and Routing Systems