Vision VR48 4 Series User Manual page 242

242 Vision VR48 Series 4 Router User Manual
After setting the surface, press the Go to Home button on the Pendant.
With the machine now set up, install the 0.030" flex cutter and adjust for proper depth using the
micrometer. In the Vision 9 software, send the job to the machine by clicking on the Engrave icon in the
Cut Toolbox and run the job.
After the engraved areas are finished, remove the flex cutter and install the 1/8" End Mill. Set the
micrometer back to its 0 point. Turn on the Green color and turn off all the other colors (using the CTRL
+ Left click method), so that we can only send the profile cut tool path to the machine.
When sending this job to the machine, be advised that cutting rates vary with each machine, material
thickness and cutter being used. Please refer to the recommendations by the manufacturer of your
cutting tool as well as Vision for proper settings.
© 2015 Vision Engraving and Routing Systems