Vision VR48 4 Series User Manual page 84

84 Vision VR48 Series 4 Router User Manual
Note: Many of the following features can be set from the Vision Pro software. When the Engrave icon
is selected, select the icon with three dots to the right of All Tools as shown below. Settings can be
changed for the following items:
Spindle RPM, Cutting Rate, Z-Lift Height, Vacuum (or Aux) On/Off, Preset Home Position number,
Spindle On/Off, Pump (or Misting System) On/Off, Plunge Rate, Z Up Rate, Z Dwell, Proximity
Sensor On/Off, Dry Run On/Off, and Auto Braille On/Off.
Z Lift Height - This will adjust the distance that the cutter lifts between characters while engraving. Move the
cursor to the Z Lift Height using the Y up and down jog buttons and press Enter. Using the numeric buttons, enter the
distance you would like the cutter to lift between characters. This number will be in inches or in millimeters, depending on
how the controller is configured. It will show the units that are being used on the Pendant screen. After the lift
distance is entered, press the Enter button to set this value. Press the Exit button to return to the main screen when
finished.
Z Cut Depth - This will adjust the depth of engraving or routing. It is the distance from the position that you set as the
surface, to the final depth you would like to cut. Move the cursor to the Z Cut Depth using the Y up and down jog buttons
© 2015 Vision Engraving and Routing Systems