Table of Contents
Advertisement
Example Jobs
185
At this point, the file is ready to be sent to the engraver. Place the reverse engraver's plastic material on
the t-slot table on top of Multi Mat. Set the engraving depth to slightly more than the cap layer for your
material. In this case, the engraving depth was set to 0.020 inches (20 clicks). Send the job to the
engraver using the Engravers Plastic material setting, hook up your vacuum chip removal system and
start the job.
When the engraving is complete. Brush of any excess plastic chips from the engraved areas and color
fill these areas with an acrylic based paint. It is recommended to mask the edges of the piece before
painting. In this example, two colors were used to fill the engraved areas.
(Back of plate shown for reference)
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
