Table of Contents
Advertisement
Example Jobs
243
To send this job to the machine, select the Engrave icon from the left toolbar, choose your device and
select the proper tool settings, then click on the Engrave icon in the Cut Toolbox.
Once the profile cut is finished, we need to remove the cut out sign and flip it over to drill and install the
braille raster beads. Use a small, sharp edged tool to carefully pry the cut out sign away from the
vacuum table.
Flip it over and carefully align it back inside the cut out area.
NOTE: The material could have been profile cut first, then aligned using the table's rulers. The file
setup would be different than in this example (i.e., the plate size would match the profile cut
dimensions of the piece).
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
