Vision VR48 4 Series User Manual page 246

246 Vision VR48 Series 4 Router User Manual
After running the job, raise the inserter so that the inserter tip is well above the bottom of the spindle
nose cone.
Install the 0.015 Flex cutter and set the depth to 0.035 inches (35 clicks). Apply a piece of applique
above the braille rasters as shown. Press lightly to secure it with the adhesive. Note that the applique
has a pressure and time sensitive adhesive on the back side. Applying excessive pressure or letting
the applique sit for more than an hour or so after applying it to the substrate material will make
removing the excess applique material very difficult.
To send only the tool path of the raised text, turn off all colors except for cyan.
© 2015 Vision Engraving and Routing Systems