Vision VR48 4 Series User Manual page 114

114 Vision VR48 Series 4 Router User Manual
The following settings will need to be changed depending on which engraver or router is being used.
For the VR48 Router: Flip Image - Vertical, Rotate Image - 0.
The camera IP address must be set. Select the Configure icon next to the Camera Type. The following
window will appear. Note - if the camera is not listed in the available device list, place a check mark in
the box in the lower left corner of this window - Show unreachable GigE Vision Devices.
© 2015 Vision Engraving and Routing Systems