Vision VR48 4 Series User Manual page 166

166 Vision VR48 Series 4 Router User Manual
A Clip Art image will be added to the badge. The image is GENE0038.CDL from the Vision software clip
art in the General folder (installed as C:\Vision Express 9\ClipArt\GENERAL. If you are using Vision
Expert or Vision Pro, the folder name will reflect your particular version). To import the clip art, simply
browse the folder in Windows Explorer and drag the file to the engraving area on the plate within the
Vision software. the image will be quite large, so it must be re-sized to fit, either by changing the size
manually on the toolbar, or by selecting the object and clicking on a corner node (holding down the left
mouse button) and dragging the corner to make the image smaller.
For this example, the image was re-sized to 0.5 x 0.5 inches (12.7 x 12.7 mm) and located at X 0.75, Y
1.875 as shown below.
Next, three text fields are entered with the Text Compose tool. At first, when clicking in the middle of the
Plate Object, the text field is set to centered within the plate and auto sized. We will adjust the text frame
size and location using text Frame mode. To enable, select the Toolbar Mode Icon on the toolbar (only
visible after selecting text, or after clicking on the Text Compose icon, then clicking within the plate
object), then select the Frame mode. This will allow sizing and placement of the text field.
© 2015 Vision Engraving and Routing Systems