Using A Network Hub - Only - Vision VR48 4 Series User Manual

Series 4 Contoller and Vision 9 Software Installation 39
3.4

Using a Network Hub - ONLY

Connection from PC to Hub or Router to Machine or Controller
Once the VR48 is connected to a hub or router, and the hub or router is connected to your computer's
network port, turn the machine on. Make sure all 4 emergency stops are not pressed. The main power
switch is located on the left side of the machine. The safety key switch for the VR48 is located on the
front left of the machine. Turn the main power switch to On, then turn the safety key switch to On. Once
the machine has initialized, plug the supplied Vision USB drive (or Orange USB Dongle) into an
available USB port on your computer.
NOTE - This installation is performed on a Windows 7 PC. For Windows XP, Windows 8, Windows 8.1
or Windows 10, the screens are slightly different.
The computer will recognize the USB drive
Select Open folder to view files.
and the following screen will appear.
Select Continue without scanning.
© 2015 Vision Engraving and Routing Systems