Table of Contents
Advertisement
Example Jobs
245
The Vision 9 software will automatically select only the braille dots on the screen and apply the correct
parameters for drilling the holes. Click on Engrave to send these two jobs to the machine.
After drilling the holes, lower the braille inserter by loosening the inserter clamp and remove the braille
drill tool from the spindle. Note that when lowered properly, the inserter flange will be flush with the
mounting bracket surface and the depth pin will protrude above the flange top surface. Tighten the
clamp after the inserter is lowered into place.
Run the second job to install the raster beads into the material. Note: In this example file, clear raster
beads were used to blend in with the surface of the sign.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
