Table of Contents
Advertisement
The DACS Camera System
117
An image may or may not appear on screen at this time. Select File from the top menu bar and click on
Exposure Control.
Adjust the Exposure near the middle of its adjustment, then click on OK.
Again, an image may still not appear. It is possible that the camera's aperture is adjusted to over or
under-expose the image. To adjust the aperture and change the amount of light entering the camera,
loosen the bottom thumbscrew on the camera and turn the aperture adjustment ring below it to the left or
right. Watch the image on the DACS software screen. As the aperture is adjusted, the screen image will
become lighter or darker. The camera focus may also need to be adjusted. This is best performed after
the aperture is adjusted.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
