Vision VR48 4 Series User Manual page 164

164 Vision VR48 Series 4 Router User Manual
Holding Down Material
Secure the material on the t-slot table. It is best to use Multi Mat to hold the material in place, but keep
in mind that since we are cutting completely through, there will likely be cut marks into the Multi Mat
when the job is complete. A better procedure is to use a piece of sacrificial material on top of the Multi
Mat. DO NOT place the material to be cut directly on the t-slot table. If you do, then the cutter will cut
into the t-slot table and permanently damage the surface. Other methods for holding material down are
in the section Holding Down Material.
© 2015 Vision Engraving and Routing Systems