Vision VR48 4 Series User Manual page 70

70 Vision VR48 Series 4 Router User Manual
Setting Up Cut Files
When using the Cutting Pad or MultiMat material under the substrate being cut, the knife must be set to
slightly "over cut" the substrate. The procedure for setting up the proper cutting depth is described
below.
Open the Vision Software. The first step in creating cut files is to understand that the Oscillating Knife
ONLY recognizes objects drawn in PEN 31. To create a custom pen using pen 31 in any color desired,
double click on any of the color swatches at the bottom of the Vision software screen. In this example,
the Red color swatch was chosen.
The Edit Color window will appear. Change the Pen to 31 and set the Depth to 0.035 when using the
Cutting Pad. (If using the MultiMat, set the Depth to 0.005). Click on Add once these changes have
been made.
© 2015 Vision Engraving and Routing Systems