Table of Contents
Advertisement
Example Jobs
239
Tool Setup:
As described at the top of this section, 4 cutters are used in this example. Cutters 1, 2 and 4 need to be
zeroed in the spindle with the micrometer set to 0. The cutting depth for cutter #3 will be set using the
stacked material method as described in the Level 1 Job Example for Profile Cutting.
The following lists the depth settings and applications for the tools used.
To set the depth of the 1/8" End Mill, position the nose cone so that the cutter can drop off the side of
the 1/8" acrylic material and stop when hitting the vacuum table (or in this case, the MDF material used
as a spoil board on top of the vacuum table) as shown below. Make sure the micrometer is set to the
same 0 as when setting the other cutters.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
