Maintenance
335
X and Y Axis Bearings and Rails
NOTE - With the machine POWERED OFF, you can move the X and Y Axis (gantry and router
head) manually to access areas for cleaning and lubricating the machine. Press on the left or
right gantry supports to move it up or down the length of the router table. To move the router
head, press on the left or right sides of the router head to move it left or right.
Use a paper towel to wipe down the Y Axis stainless steel rails. Using the included grease gun and
grease fitting adapter, supply grease to the grease fittings for the bearings every 60 days. Only 1/2 to 1
pump of the grease gun is required. (The grease fitting adapter is supplied to allow access to the all
grease fittings). Grease should lightly be applied to the Y Axis Racks monthly.
© 2015 Vision Engraving and Routing Systems