Table of Contents
Advertisement
234
Vision VR48 Series 4 Router User Manual
Choose the 1/8th inch End Mill as the Tool. Set the Depth to slightly more than the material thickness (in
this case the material was 0.125", so the depth was set to 0.130"). Set the Color to Green (or another
color you are not already using). Click on the
icon to set the number of passes.
Set the number of passes to 1, then click on OK to close the Engraver Parameters window. Click on OK
to close the Male tool path window.
© 2015 Vision Engraving and Routing Systems
Advertisement
Table of Contents
